180 nm XT018 3.3V PLL IP name: TS_FS_9M70_X8 Integer-N-PLL-based HF Frequency Synthesizer and Clock Generator with integrated Loop Filter. TES Electronic Solutions GmbH 180 nm XT018 3.3V Bias IP name: TS_IREF_88uA_X8; GDSII; Schematic A current reference biasing circuit which provides a sink/source ZTAT temperature-independent current from 250nA up to 88μA and supplied with 3.3V.
TES Electronic Solutions GmbH 180 nm XT018 3.3V Driver IP name: TS_LEDDRV_30V0A5_X8; GDSII; Schematic A 30V 0.5A non-synchronous hysteretic Buck LED driver which operates with an input voltage range of 20 VDC to 30 VDC and provides an output LED current of 0.5A.
TES Electronic Solutions GmbH 180 nm XT018 -30V up to 30V Bias IP name: TS_OVLO_3V3_X8; GDSII, Schematic A compact Over-Voltage Lockout (OVLO) IP designed to protect battery-powered electronic systems against over-voltage and reverse-polarity faults of up to ±30 V.
TES Electronic Solutions GmbH 180 nm XT018 5V Sensor IP name: TS_SN_TEMP_X8 Temperature sensor generating an output voltage linearly increasing with junction temperature and trimmable to 2V at 60°C. TES Electronic Solutions GmbH 180 nm XT018 10V up to 30V DC/DC Converters IP name: TS_SPLITPI_3V3_X8; GDSII, Schematic A cascaded 3.3V boost buck converter depending on variable-frequency switching-mode. It regulates voltage to typically 3.3V, either from 10V or more on sense-input V24V and power-input PV24V in buck-mode or from battery voltage as low as 1.9V in boost-buck mode.
TES Electronic Solutions GmbH 180 nm XT018 3.3V Other IP name: TS_SW_4Cap_X8 Quadruple capacitor switch that can be used for resonator/transducer trimming. TES Electronic Solutions GmbH 180 nm XC018 2.5V up to 5.5V DC/DC Converters IP Name: TS_SWC_DCDC_3V6_X8; GDSII, Schematic A switching-mode power converter which regulates its output voltage to 3.6V with an output load current of 10mA, from an input voltage VBAT ranging from 2.5V to 5.5V. The DC-DC converter architecture is based on the switched capacitor design which provides multiple advantages such as being inductor less (better EMI performance)
TES Electronic Solutions GmbH 180 nm XT018 5V Temperature Sensor IP name: TS_TEMP_DET_X8; GDSII; Schematic A hysteresis temperature detector that asserts output OVERTJ once junction temperature exceeds 147.2°C and subsequently stays above 138.2°C.
TES Electronic Solutions GmbH 180 nm XT018 3.3V Other IP name: TS_VA_LNDC_X8 DC-voltage amplifier with very-high-gain and very low output noise. The gain is programmable with 1%-precision up to 400V/V. TES Electronic Solutions GmbH 180 nm XT018 3.3V Voltage Buffer IP Name: TS_VBUFF_300uA_X8; GDSII, Schematic A unity gain buffer which has a 5.5MHz unity gain bandwidth while driving a 2pF capacitance. It can drive a current up to ±300uA continuously and will not oscillate while driving larger capacitive loads up to 50pF. The voltage buffer is typically used for buffering small voltage such as bandgap voltage VBG (1.2V).
TES Electronic Solutions GmbH 180 nm XT018 3.3V Voltage Buffer IP name: TS_VBUFF_6mA_X8; GDSII, Schematic A unity gain buffer which has a DC gain of 110dB and 6.5MHz unity gain bandwidth. It can source a current up to 6.5mA and sink a current up to 4.5mA.
TES Electronic Solutions GmbH 180 nm XT018 3.3V Voltage Regulator IP name: TS_VR_1V8_X8; GDSII, Schematic 3.3V to 1.8V linear voltage regulator (LDO) designed to supply the digital core of an ASIC. The maximum DC load current is 50mA. The LDO features a power good signal. It requires a 2.2µF off-chip capacitor to be connected to the output pin.
TES Electronic Solutions GmbH 180 nm XT018 5V Voltage Regulator IP name: TS_VR_3V3_X8; GDSII, Schematic 5V/3.3V low-dropout linear regulator (LDO) to supply the digital core of an analog ASIC. The LDO operates with an input voltage of 5V (supply voltage) and provides an output regulated voltage of 3.3V. The LDO can supply a maximum DC load current of 10mA.
TES Electronic Solutions GmbH 180 nm XT018 5V Voltage Regulator IP name: TS_VR_4V00_X8 4V voltage regulator capable of delivering up to 16mA. The 4V regulator operates with one precision reference voltage (2.5V). TES Electronic Solutions GmbH 180 nm XC018 2.5V up to 5.5V Oscillator IP Name: TS_XOSC_32k_X8; GDSII, Schematic A low power 32kHz Pierce oscillator that generates a VBAT-level logic square wave when a 32kHz quartz crystal is connected to its input XIN. The circuit operates with the supply voltage VBAT from 2.5V to 5.5V with a maximum current consumption less than 500nA.
TES Electronic Solutions GmbH 180 nm XT018 3.3V Oscillator IP name: TS_XOSC_40M_X8; GDSII; Schematic 8 MHz / 40 MHz highly-integrated Pierce oscillator which generates stable square-wave clock signals. It operates on a 3.3V supply and features a simple enable signal (EN) for power control, making it ideal for low-power designs.
TES Electronic Solutions GmbH All Geometries All Processes Networking IP name: TSN-EP Ethernet TSN and Automotive Ethernet End Point with RTOS and Linux support for 1G and 10G.
Fraunhofer IPMS All Geometries All Processes Networking IP name: TSN-SE Ethernet TSN and Automotive Ethernet Switched End Point with RTOS and Linux support for 1G and 10G.
Fraunhofer IPMS All Geometries All Processes Networking IP name: TSN-SW Ethernet TSN and Automotive Ethernet Switch with RTOS and Linux support for 1G and 10G.
Fraunhofer IPMS All Geometries All Processes Security IP name: Tunable Cryptography Symmetric Cryptography, Asymmetric Cryptography, Hash and MAC functions balancing Security, Speed, and Area. Secure-IC All Geometries All Processes Warping Engine IP name: Warping Engine Warping Engine for arbitrary high-performance re-mapping of bitmaps from memory-to-memory or memory-to-stream supporting cropping and scaling.
TES Electronic Solutions GmbH 180 nm XH018 2.0V … 3.6V/0.7V … 1.8V DC/DC Converters IP cell xlpbckc01_3V included in Analog Library A_CELLS_VLP Very low power DC/DC buck converter with configurable output voltage from 0.7V to 1.8V in 100mV steps X-FAB 180 nm XH018 3V Bandgaps IP cell xlpbgpc01_3v included in Analog Library A_CELLS_VLP Low power multi-voltage bandgap reference with auxiliary PTAT current source output X-FAB 180 nm XH018 3V Bandgaps IP cell xlpbgpc03_3v included in Analog Library A_CELLS_VLP Low power multi-voltage bandgap reference with auxiliary PTAT current source output and reference monitoring window comparator X-FAB 180 nm XH018 3V Comparators IP cell xlpcmppc01_3v included in Analog Library A_CELLS_VLP Low power comparator with PMOS input stage. X-FAB 180 nm XH018 3V Comparators IP cell xlpcmppc02_3v included in Analog Library A_CELLS_VLP Low power comparator with PMOS input stage. X-FAB 180 nm XH018 3V Comparators IP cell xlpcmppc03_3v included in Analog Library A_CELLS_VLP Low power comparator with PMOS input stage. X-FAB 180 nm XH018 3V Current Source IP cell xlpcsoc01_3v included in Analog Library A_CELLS_VLP Low power current source. The circuit has six outputs that drive currents of 100nA. X-FAB 180 nm XH018 3V Comparators IP cell xlpdcmc01_3v included in Analog Library A_CELLS_VLP Low power dynamic comparator with native NMOS source-driven input stage. X-FAB 