IP Portal

Sel. IP Name Category Provider Geometry Process Name Status Deliverable Description
CM1412ae Power on Reset
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

2Low consumption Power-On Reset (POR) core. The core has a voltage sense (configurable 0.9V - 5.5V), an internal current bias circuit and two configurable assertion delays (default are > 1μs and > 20μs). A configurable hysteresis (default 100mV).

CM1511ae Other
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

Low consumption combo voltage and current reference core. The circuit generates an unbuffered 1.29V, temperature compensated voltage reference (70ppm/°C) and provides a 1.6μA PMOS current branch (200ppm/°C).

CM2013ae ADC
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

Low power, general purpose, 10-bit, 50kSPS, Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) core. The circuit uses one 3.3V analog supply and one 3.3V digital supply and is targeted for microcontroller applications.

CM4013ae Oscillator
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

General purpose, low power internal oscillator core, 12MHz. The circuit has internal level shifting and start-up circuits. A 4-bit digital bus allows frequency calibration against process variations. Current consumption <40μA, supply voltage 2.7V-3.6V

CM6011ae Other
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

General purpose capacitive sensor core. The circuit is intended for touch sensing applications for use in microcontrollers and has two multiplexed inputs. 3pF input sensibility and output frequency of 460kHz - 600kHz.

CM6111ae Other
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

30V/20mA Power Driver/Switch - Two modes of operation: switch or programmable current output; short-circuit protection, over-current detection.

DAC-7bit-0.6u DAC
Ridgetop Group
0.60 µm
XC06
PT
GDSII

Low Power, Wide Supply Range, CMOS, output to pos rail

DC-DC Converter DC/DC Converters
Ridgetop Group
0.60 µm
XC06
ID
GDSII

Ultra high efficiency programmable output voltage over wide input voltage range, buck/boost. Input: 1.5V - 15V. Output 2V-6V

Comparator 0.6u Comparators
Ridgetop Group
0.60 µm
XC06
PT
GDSII

Ultra Low Power, Wide Supply Range, CMOS

BGR 0.6u Bandgaps
Ridgetop Group
0.60 µm
XC06
PT
GDSII

Low Power, Wide Supply Range, CMOS

PWM Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

250kHz PWM for DC-DC converters

High V Input Cell Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

High Voltage Input for input voltages up to 100V

ADC12b017kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 12bit resolution, 17kSps, 0.5 LSB INL, 12bit ENOB, 50µW power consumption.

ADC12b054kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 12bit resolution, 54kSps, 1.6 LSB INL, 10.5bit ENOB, 370µW power consumption

ADC16b013kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 16bit resolution, 13kSps, 12.7 bit ENOB, 50µW power consumption

ADC12b020MS350nm ADC
Fraunhofer IIS/EAS
0.35 μm
XH035
PT
GDSII
Schematic

Pipelined ADC, 12bit resolution, 20MSps, 9.6 bit ENOB@2MSps, 9.2 bit ENOB@20MSps,  2 LSB INL, 125mW power consumption

TI-RF-CMP Comparators
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-CMP is a low power CMOS RF comparator with 4 ns propagation delay and latch function. ESD protection provided.

TI-RF-DRV Driver
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-DRV is a fully differential RF driver for differential signal processing applications. Common-mode level of differential outputs is adjustable that allows to shift easily the input signals for driving single-supply ADCs. ESD protection provided.

TI-RF-MUX Multiplexer
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-MUX is a 4-to-1 RF multiplexer designed with an internal current feedback output amplifier whose gain can be adjusted externally. There is a possibility of optional usage of two 4-to-1 devices as one 8-to-1 multiplexer. ESD protection provided.

TI-RF-Switch Analogue Switches
Thesys-Intechna
0.35 μm
XH035
VS
GDSII
Schematic

The TI-RF-Switch is a broad-band dual SPDT analog switch containing two single-pole double-throw switches. Used CMOS technology provides high isolation and low insertion loss at frequencies up to 1 GHz.

TI-16PI/150M ADC
Thesys-Intechna
0.18 μm
XT018
VS
GDSII
Schematic

TI-16PI/150M is a dual-channel fully differential 16-bit ADC with pipelined architecture optimized for high dynamic performance at sample rates up to 180 MSPS.

TI-Manchester Transceiver
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-Manchester is a dual data bus transceiver designed for receiving CMOS/TTL Manchester II data, converting it and transmitting through a stepup transformer to the data bus...

ADC12b040MS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Pipeline ADC, 12bit resolution, 1-40MSps, single-end and fully differential input buffer.

TI-L500 Voltage Regulator
Thesys-Intechna
0.60 µm
XC06
PT
GDSII
Schematic

TI-L500 is a micro-power low dropout linear voltage regulator with fixed 5 V output voltage and input voltage of up to 40 V. ESD protection provided.

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

D17IP00 Analogue Switches
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP00 is a set of 4 analog switches, PMOS devices.  Designed to minimize RDS & gate capacitances.  Gate drivers for the switches included.  Max RDS for the 2 small switches are 100Ω; while 10Ω & 50Ω for the 2 larger switches.

D17IP01 Voltage Driver
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP01 is a low power digital pad driver and input, with both and out and input enabled. Operating supply voltage of 2V to 3.6V; maximum delay time of 150ns; static current is leakage; 20ns max rise/fall time for 2pF load.

D17IP02 Operational Amplifier
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP02 is a rail to rail unity gain CMOS amplifier.  It operates from 2V to 3.6V; has a quiescent current of 214uA; 50.2uV rms noise for a bandwidth of 10 Hz to 100kHz. Require an input current of 2uA; also pad compatible.

D17IP03 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP03 is an RC oscillator with built in current reference.  The design uses mixed TC resistors and matched MOS VT to reduce PVT dependence.  It is designed to run at 800 KHz nominal with a quiescent current of  20uA.

 

MP = Mass ProductionPT = Prototyping, Silicon provenID = in DesignVS = Verified by Simulations (Soft-IP)

Displaying results 241 to 270 out of 390

*Disclaimer:
The Intellectual Partner Network is a web database provided by X-FAB in cooperation with selected partners. Both X-FAB and a variety of different IP supplier offer their IP to customers using X-FAB’s foundry process. X-FAB will support customers to get in direct contact with the relevant IP supplier.

X-FAB will take no responsibility nor any liability whatsoever for the information or products offered or provided by the other IP suppliers at the database of the Intellectual Partner Network. X-FAB shall have no liability towards the customers for any use of and/or reliance of the products provided by the other IP suppliers at the database of the Intellectual Partner Network.

X-FAB's own IP is subject to a license agreement. X-FAB IP marked with “*” are part of the Master Kit or Master Kit Plus library. If you can not find the IP you are looking for, please contact the respective sales manager in your region. We continuously extend our libraries and offer a custom cell development service as well.