IP Portal

Sel. IP Name Category Provider Geometry Process Name Status Deliverable Description
ADC12b017kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 12bit resolution, 17kSps, 0.5 LSB INL, 12bit ENOB, 50µW power consumption.

ADC12b054kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 12bit resolution, 54kSps, 1.6 LSB INL, 10.5bit ENOB, 370µW power consumption

ADC16b013kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 16bit resolution, 13kSps, 12.7 bit ENOB, 50µW power consumption

ADC12b020MS350nm ADC
Fraunhofer IIS/EAS
0.35 μm
XH035
PT
GDSII
Schematic

Pipelined ADC, 12bit resolution, 20MSps, 9.6 bit ENOB@2MSps, 9.2 bit ENOB@20MSps,  2 LSB INL, 125mW power consumption

TI-RF-CMP Comparators
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-CMP is a low power CMOS RF comparator with 4 ns propagation delay and latch function. ESD protection provided.

TI-RF-DRV Driver
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-DRV is a fully differential RF driver for differential signal processing applications. Common-mode level of differential outputs is adjustable that allows to shift easily the input signals for driving single-supply ADCs. ESD protection provided.

TI-RF-MUX Multiplexer
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-MUX is a 4-to-1 RF multiplexer designed with an internal current feedback output amplifier whose gain can be adjusted externally. There is a possibility of optional usage of two 4-to-1 devices as one 8-to-1 multiplexer. ESD protection provided.

TI-RF-Switch Analogue Switches
Thesys-Intechna
0.35 μm
XH035
VS
GDSII
Schematic

The TI-RF-Switch is a broad-band dual SPDT analog switch containing two single-pole double-throw switches. Used CMOS technology provides high isolation and low insertion loss at frequencies up to 1 GHz.

TI-16PI/150M ADC
Thesys-Intechna
0.18 μm
XT018
VS
GDSII
Schematic

TI-16PI/150M is a dual-channel fully differential 16-bit ADC with pipelined architecture optimized for high dynamic performance at sample rates up to 180 MSPS.

TI-Manchester Transceiver
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-Manchester is a dual data bus transceiver designed for receiving CMOS/TTL Manchester II data, converting it and transmitting through a stepup transformer to the data bus...

ADC12b040MS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Pipeline ADC, 12bit resolution, 1-40MSps, single-end and fully differential input buffer.

TI-L500 Voltage Regulator
Thesys-Intechna
0.60 µm
XC06
PT
GDSII
Schematic

TI-L500 is a micro-power low dropout linear voltage regulator with fixed 5 V output voltage and input voltage of up to 40 V. ESD protection provided.

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

D17IP00 Analogue Switches
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP00 is a set of 4 analog switches, PMOS devices.  Designed to minimize RDS & gate capacitances.  Gate drivers for the switches included.  Max RDS for the 2 small switches are 100Ω; while 10Ω & 50Ω for the 2 larger switches.

D17IP01 Voltage Driver
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP01 is a low power digital pad driver and input, with both and out and input enabled. Operating supply voltage of 2V to 3.6V; maximum delay time of 150ns; static current is leakage; 20ns max rise/fall time for 2pF load.

D17IP02 Operational Amplifier
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP02 is a rail to rail unity gain CMOS amplifier.  It operates from 2V to 3.6V; has a quiescent current of 214uA; 50.2uV rms noise for a bandwidth of 10 Hz to 100kHz. Require an input current of 2uA; also pad compatible.

D17IP03 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP03 is an RC oscillator with built in current reference.  The design uses mixed TC resistors and matched MOS VT to reduce PVT dependence.  It is designed to run at 800 KHz nominal with a quiescent current of  20uA.

D17IP04 Digital Filter
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP04 is a 3rd order cascade of integrators and comb, or differentiators,(CIC) digital filter.  In converts a single channel digital bit stream into a 16 bit output word with a 256 clock latency.  The design is optimized for area and power.

D17IP05 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP05 is both a current and voltage reference. The current reference uses a negative TC resistor and VBE to reduce the temperature dependence. The output currents are 2µA and a programmable 200nA, 400nA, 800nA, or 1µA, sinking current. 

D17IP06 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP06 is a digitally configurable current and voltage generator.  The reference includes a temperature compensated current and voltage source.  Output of the amplifiers can drive capacitive modes and settle with 16 bit accuracy within 500ns.

D17IP07 Under Voltage Detector
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP07 is an under voltage detector.  It has an enable signal to allow for detect control. It is designed to output an active low signal when the supply voltage drops below 2V for longer than 1 ms.

D17IP08 Interface
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP08 is a configurable 32 channel sample and hold input interface.  The input connects to a 8pF capacitor to ground through a selection multiplexer.  It can be configured as a daisy chain sample and hold circuit for delay line operations.

D17IP09 Transimpedance Amplifier
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP09 is an 8 channel bank of transimpedance amplifiers.  It has a programmable transimpedance gain.  It is internally compensated and supplies a virtual ground to both sink and source current at the input.

D17IP10 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP10 is a programmable RC oscillator with temperature compensated self bias.  The oscillator has 4 bit of input trim range to account for +/- 20% PVT variation.  The bas frequency of the oscillator is 1.6MHz. 

D17IP11 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP11 is both a current and voltage reference with trimming capability.  The current reference uses a negative TC resistor and VBE to reduce the temperature dependence.  The output currents are 2µA and 1µA x2.

D17IP12 Analog Filter
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP12 is a 3rd order analog filter for video applications.  It has the architecture of a Tow-Thomas biquad.  The biquad is design for frequency tunning.  The implementation is an RC continuous time.  The cut off frequency is 6.5 MHz.

D17IP13 Voltage Driver
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP013D17IP13 is a video amplifier designed to drive 75 ohm coaxial cable.  It is configured in the inverting mode and allows minimal distortion for input signals up to 1Vp-p.  The output can be muted, gained or attenuated.

D17IP15 Voltage Regulator
Desert Microtechnology
1.00 µm
XC10
MP
GDSII
Schematic

D17IP15 is a voltage regulator with built in reference.  Has 5V low drop out regulator that can operate from 5.5V - 25V supply.  Has 14V regulator when the supply is > 25V.  Can be paired with D17IP16 to generate a voltage oscillator.

D17IP16 Oscillator
Desert Microtechnology
1.00 µm
XC10
MP
GDSII
Schematic

D17IP16 is a voltage oscillator at 500 kHz.  It requires 3 input reference voltages 1.064V, 1.275V and 0.762V.  These voltages can be generated with the D17IP15.  Output is to designed to drive on chip light loads.

 

MP = Mass ProductionPT = Prototyping, Silicon provenID = in DesignVS = Verified by Simulations (Soft-IP)

Displaying results 121 to 150 out of 381

*Disclaimer:
The Intellectual Partner Network is a web database provided by X-FAB in cooperation with selected partners. Both X-FAB and a variety of different IP supplier offer their IP to customers using X-FAB’s foundry process. X-FAB will support customers to get in direct contact with the relevant IP supplier.

X-FAB will take no responsibility nor any liability whatsoever for the information or products offered or provided by the other IP suppliers at the database of the Intellectual Partner Network. X-FAB shall have no liability towards the customers for any use of and/or reliance of the products provided by the other IP suppliers at the database of the Intellectual Partner Network.

X-FAB's own IP is subject to a license agreement. X-FAB IP marked with “*” are part of the Master Kit or Master Kit Plus library. If you can not find the IP you are looking for, please contact the respective sales manager in your region. We continuously extend our libraries and offer a custom cell development service as well.