IP Portal

Sel. IP Name Category Provider Geometry Process Name Status Deliverable Description
ADC12b017kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 12bit resolution, 17kSps, 0.5 LSB INL, 12bit ENOB, 50µW power consumption.

ADC12b054kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 12bit resolution, 54kSps, 1.6 LSB INL, 10.5bit ENOB, 370µW power consumption

ADC16b013kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XH018
PT
GDSII
Schematic

Cyclic single ADC, 16bit resolution, 13kSps, 12.7 bit ENOB, 50µW power consumption

ADC12b020MS350nm ADC
Fraunhofer IIS/EAS
0.35 μm
XH035
PT
GDSII
Schematic

Pipelined ADC, 12bit resolution, 20MSps, 9.6 bit ENOB@2MSps, 9.2 bit ENOB@20MSps,  2 LSB INL, 125mW power consumption

ADC12b040MS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Pipeline ADC, 12bit resolution, 1-40MSps, single-end and fully differential input buffer.

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

PGA180nm AFE Amplifier
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
PT
Schematic
GDSII

Programmable Gain Amplifier, Gain settings 0.5 – 128 (9 steps), (optional) 8-to-1 input mux, (optional) internal chopper stabilizer, temp range from -40 to 175°C

IPMS_430 Microprocessor
Soft IP
Fraunhofer IPMS
All Geometries
All Processes
PT
VHDL
Verilog

Compatible in its properties, like instruction set, address space and time behavior with the standard CPU MSP430 from TI. Important features:
- 16 bit Risc CPU
- 7 address modes for source operands
- several low power features

IPMS_16CXX Microprocessor
Soft IP
Fraunhofer IPMS
All Geometries
All Processes
PT
VHDL
Verilog

8 Bit Microprocessor. The core IPMS_16CXX is a 8-bit microcontroller compatible to PIC 16CXX-family from Microchip.

IPMS_CAN_FD Soft IP
Fraunhofer IPMS
All Geometries
All Processes
PT
VHDL
Verilog

IPMS_CAN is a CAN bus controller that performs serial communication according to the CAN 2.0B and the CAN FD specification.It is compatible to ISO CAN FD andthe non-ISO (Bosch) CAN FD standard and has extended time stamp and time trigger capabilities.

IPMS_LIN Soft IP
Fraunhofer IPMS
All Geometries
All Processes
PT
VHDL
Verilog

LIN (Local Interconnect Network) is a serial communication protocol used in low cost automotive networks. It enables cost efficient bus communication for applications where the bandwidth of CAN is not required. Support of LIN specification 2.2A

IMMS SENT Transmitter Soft IP
IMMS GmbH
All Geometries
All Processes
PT
Verilog

Silicon-proven Verilog implementation of a flexible configurable SENT transmitter according to SAE standard J2716 JAN2010 “SENT – Single Edge Nibble Transmission for Automotive Applications”. Up to 16-bit data from two independent sensors.

MR74039 Other
Moortec Semiconductor Ltd
0.35 μm
XH035
ID
GDSII
Verilog

The MR74039 is a fully integrated temperature sensor with a 12 Bit digital output designed in the XFab 0.35um XH035 process. It utilises a 12 bit Sigma Delta ADC for increased precision (0.25ºC). The temperature measurement range is fr

DAC-7bit-0.6u DAC
Ridgetop Group
0.60 µm
XC06
PT
GDSII

Low Power, Wide Supply Range, CMOS, output to pos rail

DC-DC Converter DC/DC Converters
Ridgetop Group
0.60 µm
XC06
ID
GDSII

Ultra high efficiency programmable output voltage over wide input voltage range, buck/boost. Input: 1.5V - 15V. Output 2V-6V

Comparator 0.6u Comparators
Ridgetop Group
0.60 µm
XC06
PT
GDSII

Ultra Low Power, Wide Supply Range, CMOS

BGR 0.6u Bandgaps
Ridgetop Group
0.60 µm
XC06
PT
GDSII

Low Power, Wide Supply Range, CMOS

PWM Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

250kHz PWM for DC-DC converters

High V Input Cell Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

High Voltage Input for input voltages up to 100V

Sub 1dB LNA+mixer LNA
Mixer
Saul Research
0.35 μm
XH035
PT
GDSII
Schematic

LNA  and optional mixer based on XH035 process. Measured noise figure below 1dB including mixer. Described in a paper on the web site.  The techniques are readily applied to other processes.

Low Power DDS Other
Saul Research
0.35 μm
XH035
PT
GDSII
Schematic

Novel aproach to Direct Digital Synthesis, using a voltage-ladder reference. Accuracy is achieved by using a full resistor ladder array, so bit size equivalent to 12 bits has been shown. Prototypes using an 8 bit system are available on

Analogue SSB Chip Other
Saul Research
0.35 μm
XH035
PT
GDSII
Schematic

Very low power (3V, 25uA) 90 degree analogue phase shifter for SSB encoding/decoding. A full description is on the web site, with all measurements.

VREG1_8 Voltage Regulator
Suter IC-Design AG
0.18 μm
XC018
MP
GDSII
Schematic

Low power voltage regulator for 1.8V logic, requires only an external capacitor, available for XC018/XH018 MOS3LP and MOS5LP, different option available on request.

XTAL5M Crystal Oscillators
Suter IC-Design AG
0.18 μm
XC018
MP
GDSII
Schematic

Low power crystal oscillator for resonator with fast start-up, available for XC018/XH018 MOS3LP, including pads, different pads on request.

TI-RF-CMP Comparators
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-CMP is a low power CMOS RF comparator with 4 ns propagation delay and latch function. ESD protection provided.

TI-RF-DRV Driver
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-DRV is a fully differential RF driver for differential signal processing applications. Common-mode level of differential outputs is adjustable that allows to shift easily the input signals for driving single-supply ADCs. ESD protection provided.

TI-RF-MUX Multiplexer
Thesys-Intechna
0.60 µm
XT06
VS
GDSII
Schematic

TI-RF-MUX is a 4-to-1 RF multiplexer designed with an internal current feedback output amplifier whose gain can be adjusted externally. There is a possibility of optional usage of two 4-to-1 devices as one 8-to-1 multiplexer. ESD protection provided.

TI-RF-Switch Analogue Switches
Thesys-Intechna
0.35 μm
XH035
VS
GDSII
Schematic

The TI-RF-Switch is a broad-band dual SPDT analog switch containing two single-pole double-throw switches. Used CMOS technology provides high isolation and low insertion loss at frequencies up to 1 GHz.

TI-16PI/150M ADC
Thesys-Intechna
0.18 μm
XT018
VS
GDSII
Schematic

TI-16PI/150M is a dual-channel fully differential 16-bit ADC with pipelined architecture optimized for high dynamic performance at sample rates up to 180 MSPS.

 

MP = Mass ProductionPT = Prototyping, Silicon provenID = in DesignVS = Verified by Simulations (Soft-IP)

Displaying results 31 to 60 out of 381

*Disclaimer:
The Intellectual Partner Network is a web database provided by X-FAB in cooperation with selected partners. Both X-FAB and a variety of different IP supplier offer their IP to customers using X-FAB’s foundry process. X-FAB will support customers to get in direct contact with the relevant IP supplier.

X-FAB will take no responsibility nor any liability whatsoever for the information or products offered or provided by the other IP suppliers at the database of the Intellectual Partner Network. X-FAB shall have no liability towards the customers for any use of and/or reliance of the products provided by the other IP suppliers at the database of the Intellectual Partner Network.

X-FAB's own IP is subject to a license agreement. X-FAB IP marked with “*” are part of the Master Kit or Master Kit Plus library. If you can not find the IP you are looking for, please contact the respective sales manager in your region. We continuously extend our libraries and offer a custom cell development service as well.