IP Portal

Sel. IP Name Category Provider Geometry Process Name Status Deliverable Description
CM1511ae Other
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

Low consumption combo voltage and current reference core. The circuit generates an unbuffered 1.29V, temperature compensated voltage reference (70ppm/°C) and provides a 1.6μA PMOS current branch (200ppm/°C).

CM2013ae ADC
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

Low power, general purpose, 10-bit, 50kSPS, Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) core. The circuit uses one 3.3V analog supply and one 3.3V digital supply and is targeted for microcontroller applications.

CM4013ae Oscillator
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

General purpose, low power internal oscillator core, 12MHz. The circuit has internal level shifting and start-up circuits. A 4-bit digital bus allows frequency calibration against process variations. Current consumption <40μA, supply voltage 2.7V-3.6V

CM6011ae Other
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

General purpose capacitive sensor core. The circuit is intended for touch sensing applications for use in microcontrollers and has two multiplexed inputs. 3pF input sensibility and output frequency of 460kHz - 600kHz.

CM6111ae Other
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

30V/20mA Power Driver/Switch - Two modes of operation: switch or programmable current output; short-circuit protection, over-current detection.

PWM Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

250kHz PWM for DC-DC converters

High V Input Cell Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

High Voltage Input for input voltages up to 100V

ADC12b020MS350nm ADC
Fraunhofer IIS/EAS
0.35 μm
XH035
PT
GDSII
Schematic

Pipelined ADC, 12bit resolution, 20MSps, 9.6 bit ENOB@2MSps, 9.2 bit ENOB@20MSps,  2 LSB INL, 125mW power consumption

TI-RF-Switch Analogue Switches
Thesys-Intechna
0.35 μm
XH035
VS
GDSII
Schematic

The TI-RF-Switch is a broad-band dual SPDT analog switch containing two single-pole double-throw switches. Used CMOS technology provides high isolation and low insertion loss at frequencies up to 1 GHz.

D17IP00 Analogue Switches
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP00 is a set of 4 analog switches, PMOS devices.  Designed to minimize RDS & gate capacitances.  Gate drivers for the switches included.  Max RDS for the 2 small switches are 100Ω; while 10Ω & 50Ω for the 2 larger switches.

D17IP01 Voltage Driver
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP01 is a low power digital pad driver and input, with both and out and input enabled. Operating supply voltage of 2V to 3.6V; maximum delay time of 150ns; static current is leakage; 20ns max rise/fall time for 2pF load.

D17IP02 Operational Amplifier
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP02 is a rail to rail unity gain CMOS amplifier.  It operates from 2V to 3.6V; has a quiescent current of 214uA; 50.2uV rms noise for a bandwidth of 10 Hz to 100kHz. Require an input current of 2uA; also pad compatible.

D17IP03 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP03 is an RC oscillator with built in current reference.  The design uses mixed TC resistors and matched MOS VT to reduce PVT dependence.  It is designed to run at 800 KHz nominal with a quiescent current of  20uA.

D17IP04 Digital Filter
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP04 is a 3rd order cascade of integrators and comb, or differentiators,(CIC) digital filter.  In converts a single channel digital bit stream into a 16 bit output word with a 256 clock latency.  The design is optimized for area and power.

D17IP05 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP05 is both a current and voltage reference. The current reference uses a negative TC resistor and VBE to reduce the temperature dependence. The output currents are 2µA and a programmable 200nA, 400nA, 800nA, or 1µA, sinking current. 

D17IP06 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP06 is a digitally configurable current and voltage generator.  The reference includes a temperature compensated current and voltage source.  Output of the amplifiers can drive capacitive modes and settle with 16 bit accuracy within 500ns.

D17IP07 Under Voltage Detector
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP07 is an under voltage detector.  It has an enable signal to allow for detect control. It is designed to output an active low signal when the supply voltage drops below 2V for longer than 1 ms.

D17IP08 Interface
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP08 is a configurable 32 channel sample and hold input interface.  The input connects to a 8pF capacitor to ground through a selection multiplexer.  It can be configured as a daisy chain sample and hold circuit for delay line operations.

D17IP09 Transimpedance Amplifier
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP09 is an 8 channel bank of transimpedance amplifiers.  It has a programmable transimpedance gain.  It is internally compensated and supplies a virtual ground to both sink and source current at the input.

D17IP10 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP10 is a programmable RC oscillator with temperature compensated self bias.  The oscillator has 4 bit of input trim range to account for +/- 20% PVT variation.  The bas frequency of the oscillator is 1.6MHz. 

D17IP11 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP11 is both a current and voltage reference with trimming capability.  The current reference uses a negative TC resistor and VBE to reduce the temperature dependence.  The output currents are 2µA and 1µA x2.

D17IP12 Analog Filter
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP12 is a 3rd order analog filter for video applications.  It has the architecture of a Tow-Thomas biquad.  The biquad is design for frequency tunning.  The implementation is an RC continuous time.  The cut off frequency is 6.5 MHz.

D17IP13 Voltage Driver
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP013D17IP13 is a video amplifier designed to drive 75 ohm coaxial cable.  It is configured in the inverting mode and allows minimal distortion for input signals up to 1Vp-p.  The output can be muted, gained or attenuated.

D17IP14 Transceiver
Desert Microtechnology
0.35 μm
XH035
PT
Layout
Schematic

D17IP14 is a low voltage differential signal (LVDS) receiver (RX) for digital video data transfer.  It adherers to LVDS standards.  It has a 400 ohm input impedance. It amplifies the input signals to CMOS levels, 0 to 3.3V. 

AR32X3A ADC
Archband Labs Inc.
0.25 μm
FC025
PT
GDSII

AR32X3A is a 16-bit ADC for measurement purpose in 0.25µm node.

AR25X01 Other
Archband Labs Inc.
0.25 μm
FC025
PT
GDSII

AR25X01 is a 35mA LDO with the capless option in 0.25µm node

acsoc01_3v3 Current Source
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V acsoc01_3v3 is a compact general purpose current source. The circuit has four outputs that drive currents of 200nA each. 

abiac02_3v3 Bias
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V abiac02_3v3 is a general purpose bias cell. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 10µm/4µm and NMOS with W/L ratio od 6µm/12µm.

abiac03_3v3 Bias
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V abiac03_3v3 is a general purpose bias cell. The circuit forces a current of 10µA (approx.) to flow through PMOS with W/L ratio of 24µm/2µm and NMOS with W/L ratio od 14µm/6µm.

abiac01_3v3 Bias
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V abiac01_3v3 is a general purpose bias cell. The circuit forces a current of 200nA (approx.) to flow through PMOS with W/L ratio of 8µm/10µm and NMOS with W/L ratio of 4µm/20µm.

 

MP = Mass ProductionPT = Prototyping, Silicon provenID = in DesignVS = Verified by Simulations (Soft-IP)

Displaying results 241 to 270 out of 381

*Disclaimer:
The Intellectual Partner Network is a web database provided by X-FAB in cooperation with selected partners. Both X-FAB and a variety of different IP supplier offer their IP to customers using X-FAB’s foundry process. X-FAB will support customers to get in direct contact with the relevant IP supplier.

X-FAB will take no responsibility nor any liability whatsoever for the information or products offered or provided by the other IP suppliers at the database of the Intellectual Partner Network. X-FAB shall have no liability towards the customers for any use of and/or reliance of the products provided by the other IP suppliers at the database of the Intellectual Partner Network.

X-FAB's own IP is subject to a license agreement. X-FAB IP marked with “*” are part of the Master Kit or Master Kit Plus library. If you can not find the IP you are looking for, please contact the respective sales manager in your region. We continuously extend our libraries and offer a custom cell development service as well.