IP Portal

Sel. IP Name Category Provider Geometry Process Name Status Deliverable Description
aporc03 Power on Reset
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. aporc03 is a Power-on-Reset circuit. Reset signals are generated on both the rising and falling edge of the supply voltage. During power-on, POR output follows the supply voltage as long as it is below the threshold v

aregc01 Voltage Regulator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS_HV. For MOS module only. aregc01 is a 5V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered viz its high voltage input.

aregc02 Voltage Regulator
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: A_CELLS_HV. For MOS module only. aregc02 is a 12V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered via its high-voltage input.

adrvc02 Driver
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: A_CELLS_HV. For MOS module only. adrvc02 is a driver circuit for external loads (relays, LEDs, etc). The circuit features PNOS open-drain output (high-side switch). The layout of adrvc02 makes it easy to incorporate in the flat IO ring.

adrvc03 Driver
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: A_CELLS_HV. For MOS module only. adrvc03 is a driver circuit for external loads (realys, LEDs, etc). The circuit features NMOS open-drain output (low-side switch). The layout of adrvc03 makes it easy to incorporate in the flat IO ring.

abiac04 Bias
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: A_CELLS_HV. For MOS module only. abiac04 is a high voltage bias cell. The circuit forces a current of 2µA (approx.) to flow through PHV with W/L ratio of 8µm/12µm and NHV with W/L ratio of 8µm/14µm.

arcoc07 Oscillator
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: A_CELLS_HV. For MOS module only. arcoc07 is a high-voltage 400kHz current-balancing RC oscillator with internal R and C. The cell features low temperature coefficient of clock frequency, constant duty cycle, and low power consumption.

LNA1 LNA
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: LNA Library: RF_LNA_CELLS. LNA1 is a broadband low noise amplifier. It should be bieased by the RF bias cell.

LNA2 LNA
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: LNA Library: RF_LNA_CELLS. LNA2 is a narrowband low noise amplifier. It should be biased by the RF bias cell.

DIV32 Divider
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: DIVIDER Library: RF_DIVIDER_CELLS. DIV32 is a Prescaler with a fixed ratio of 32. It should be biased by the RF bias cell.

BIAS Bias
X-FAB
0.35 μm
XH035
PT
Schematic
Layout
Analog Library

XH035: BIAS Library: RF_BIAS_CELLS. BIAS is a bias cell intended for use with the various RF building blocks. It is based on a bandgap reference and voltage-to-current converters. Current biasing is preferable because of the higher immunity to interferenc

MR74039 Other
Moortec Semiconductor Ltd
0.35 μm
XH035
ID
GDSII
Verilog

The MR74039 is a fully integrated temperature sensor with a 12 Bit digital output designed in the XFab 0.35um XH035 process. It utilises a 12 bit Sigma Delta ADC for increased precision (0.25ºC). The temperature measurement range is fr

DT2120 ADC
Digian Technology,Inc.
0.35 μm
XH035
MP
GDSII

The dT2120 is designed featuring low-voltage and low-power mono ADC (Analog-to -Digital Converter) for sensor applications. The ADC architecture is using 4th-order 1bit sigma-delta modulator with 64-times oversampling. The dT2120’s in

CM1112ae Voltage Regulator
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

General purpose linear voltage regulator. The circuit generates a 3.3V output voltage from an unregulated input voltage ranging from 5V to 30V. It features short circuit protection and 5mA output current capability.

CM1412ae Power on Reset
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

2Low consumption Power-On Reset (POR) core. The core has a voltage sense (configurable 0.9V - 5.5V), an internal current bias circuit and two configurable assertion delays (default are > 1μs and > 20μs). A configurable hysteresis (default 100mV).

CM1511ae Other
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

Low consumption combo voltage and current reference core. The circuit generates an unbuffered 1.29V, temperature compensated voltage reference (70ppm/°C) and provides a 1.6μA PMOS current branch (200ppm/°C).

CM2013ae ADC
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

Low power, general purpose, 10-bit, 50kSPS, Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) core. The circuit uses one 3.3V analog supply and one 3.3V digital supply and is targeted for microcontroller applications.

CM4013ae Oscillator
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

General purpose, low power internal oscillator core, 12MHz. The circuit has internal level shifting and start-up circuits. A 4-bit digital bus allows frequency calibration against process variations. Current consumption <40μA, supply voltage 2.7V-3.6V

CM6011ae Other
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

General purpose capacitive sensor core. The circuit is intended for touch sensing applications for use in microcontrollers and has two multiplexed inputs. 3pF input sensibility and output frequency of 460kHz - 600kHz.

CM6111ae Other
chipus
0.35 μm
XH035
PT
GDSII
Verilog
LVS Netlist

30V/20mA Power Driver/Switch - Two modes of operation: switch or programmable current output; short-circuit protection, over-current detection.

PWM Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

250kHz PWM for DC-DC converters

High V Input Cell Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

High Voltage Input for input voltages up to 100V

ADC12b020MS350nm ADC
Fraunhofer IIS/EAS
0.35 μm
XH035
PT
GDSII
Schematic

Pipelined ADC, 12bit resolution, 20MSps, 9.6 bit ENOB@2MSps, 9.2 bit ENOB@20MSps,  2 LSB INL, 125mW power consumption

TI-RF-Switch Analogue Switches
Thesys-Intechna
0.35 μm
XH035
VS
GDSII
Schematic

The TI-RF-Switch is a broad-band dual SPDT analog switch containing two single-pole double-throw switches. Used CMOS technology provides high isolation and low insertion loss at frequencies up to 1 GHz.

D17IP00 Analogue Switches
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP00 is a set of 4 analog switches, PMOS devices.  Designed to minimize RDS & gate capacitances.  Gate drivers for the switches included.  Max RDS for the 2 small switches are 100Ω; while 10Ω & 50Ω for the 2 larger switches.

D17IP01 Voltage Driver
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP01 is a low power digital pad driver and input, with both and out and input enabled. Operating supply voltage of 2V to 3.6V; maximum delay time of 150ns; static current is leakage; 20ns max rise/fall time for 2pF load.

D17IP02 Operational Amplifier
Desert Microtechnology
0.35 μm
XH035
PT
GDSII
Schematic

D17IP02 is a rail to rail unity gain CMOS amplifier.  It operates from 2V to 3.6V; has a quiescent current of 214uA; 50.2uV rms noise for a bandwidth of 10 Hz to 100kHz. Require an input current of 2uA; also pad compatible.

D17IP03 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP03 is an RC oscillator with built in current reference.  The design uses mixed TC resistors and matched MOS VT to reduce PVT dependence.  It is designed to run at 800 KHz nominal with a quiescent current of  20uA.

D17IP04 Digital Filter
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP04 is a 3rd order cascade of integrators and comb, or differentiators,(CIC) digital filter.  In converts a single channel digital bit stream into a 16 bit output word with a 256 clock latency.  The design is optimized for area and power.

D17IP05 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP05 is both a current and voltage reference. The current reference uses a negative TC resistor and VBE to reduce the temperature dependence. The output currents are 2µA and a programmable 200nA, 400nA, 800nA, or 1µA, sinking current. 

 

MP = Mass ProductionPT = Prototyping, Silicon provenID = in DesignVS = Verified by Simulations (Soft-IP)

Displaying results 151 to 180 out of 378

*Disclaimer:
The Intellectual Partner Network is a web database provided by X-FAB in cooperation with selected partners. Both X-FAB and a variety of different IP supplier offer their IP to customers using X-FAB’s foundry process. X-FAB will support customers to get in direct contact with the relevant IP supplier.

X-FAB will take no responsibility nor any liability whatsoever for the information or products offered or provided by the other IP suppliers at the database of the Intellectual Partner Network. X-FAB shall have no liability towards the customers for any use of and/or reliance of the products provided by the other IP suppliers at the database of the Intellectual Partner Network.

X-FAB's own IP is subject to a license agreement. X-FAB IP marked with “*” are part of the Master Kit or Master Kit Plus library. If you can not find the IP you are looking for, please contact the respective sales manager in your region. We continuously extend our libraries and offer a custom cell development service as well.