IP Portal

Sel. IP Name Category Provider Geometry Process Name Status Deliverable Description
MR74039 Other
Moortec Semiconductor Ltd
0.35 μm
XH035
ID
GDSII
Verilog

The MR74039 is a fully integrated temperature sensor with a 12 Bit digital output designed in the XFab 0.35um XH035 process. It utilises a 12 bit Sigma Delta ADC for increased precision (0.25ºC). The temperature measurement range is fr

DC-DC Converter DC/DC Converters
Ridgetop Group
0.60 µm
XC06
ID
GDSII

Ultra high efficiency programmable output voltage over wide input voltage range, buck/boost. Input: 1.5V - 15V. Output 2V-6V

PWM Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

250kHz PWM for DC-DC converters

High V Input Cell Other
Ridgetop Group
0.35 μm
XH035
ID
GDSII

High Voltage Input for input voltages up to 100V

VREG1_8 Voltage Regulator
Suter IC-Design AG
0.18 μm
XC018
MP
GDSII
Schematic

Low power voltage regulator for 1.8V logic, requires only an external capacitor, available for XC018/XH018 MOS3LP and MOS5LP, different option available on request.

XTAL5M Crystal Oscillators
Suter IC-Design AG
0.18 μm
XC018
MP
GDSII
Schematic

Low power crystal oscillator for resonator with fast start-up, available for XC018/XH018 MOS3LP, including pads, different pads on request.

DT2120 ADC
Digian Technology,Inc.
0.35 μm
XH035
MP
GDSII

The dT2120 is designed featuring low-voltage and low-power mono ADC (Analog-to -Digital Converter) for sensor applications. The ADC architecture is using 4th-order 1bit sigma-delta modulator with 64-times oversampling. The dT2120’s in

CM1112ae Voltage Regulator
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

General purpose linear voltage regulator. The circuit generates a 3.3V output voltage from an unregulated input voltage ranging from 5V to 30V. It features short circuit protection and 5mA output current capability.

CM1412ae Power on Reset
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

2Low consumption Power-On Reset (POR) core. The core has a voltage sense (configurable 0.9V - 5.5V), an internal current bias circuit and two configurable assertion delays (default are > 1μs and > 20μs). A configurable hysteresis (default 100mV).

CM1511ae Other
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

Low consumption combo voltage and current reference core. The circuit generates an unbuffered 1.29V, temperature compensated voltage reference (70ppm/°C) and provides a 1.6μA PMOS current branch (200ppm/°C).

CM4013ae Oscillator
chipus
0.35 μm
XH035
MP
GDSII
Verilog
LVS Netlist

General purpose, low power internal oscillator core, 12MHz. The circuit has internal level shifting and start-up circuits. A 4-bit digital bus allows frequency calibration against process variations. Current consumption <40μA, supply voltage 2.7V-3.6V

ADC12b040MS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Pipeline ADC, 12bit resolution, 1-40MSps, single-end and fully differential input buffer.

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

ADC15b008kS180nm ADC
Fraunhofer IIS/EAS
0.18 μm
XC018
XH018
MP
GDSII
Schematic

Sigma-Delta-ADC, 15bit, 8-192kS/s sampling rate, up to 4 differential inputs

D17IP00 Analogue Switches
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP00 is a set of 4 analog switches, PMOS devices.  Designed to minimize RDS & gate capacitances.  Gate drivers for the switches included.  Max RDS for the 2 small switches are 100Ω; while 10Ω & 50Ω for the 2 larger switches.

D17IP01 Voltage Driver
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP01 is a low power digital pad driver and input, with both and out and input enabled. Operating supply voltage of 2V to 3.6V; maximum delay time of 150ns; static current is leakage; 20ns max rise/fall time for 2pF load.

D17IP03 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP03 is an RC oscillator with built in current reference.  The design uses mixed TC resistors and matched MOS VT to reduce PVT dependence.  It is designed to run at 800 KHz nominal with a quiescent current of  20uA.

D17IP04 Digital Filter
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP04 is a 3rd order cascade of integrators and comb, or differentiators,(CIC) digital filter.  In converts a single channel digital bit stream into a 16 bit output word with a 256 clock latency.  The design is optimized for area and power.

D17IP05 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP05 is both a current and voltage reference. The current reference uses a negative TC resistor and VBE to reduce the temperature dependence. The output currents are 2µA and a programmable 200nA, 400nA, 800nA, or 1µA, sinking current. 

D17IP06 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP06 is a digitally configurable current and voltage generator.  The reference includes a temperature compensated current and voltage source.  Output of the amplifiers can drive capacitive modes and settle with 16 bit accuracy within 500ns.

D17IP07 Under Voltage Detector
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP07 is an under voltage detector.  It has an enable signal to allow for detect control. It is designed to output an active low signal when the supply voltage drops below 2V for longer than 1 ms.

D17IP10 Oscillator
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP10 is a programmable RC oscillator with temperature compensated self bias.  The oscillator has 4 bit of input trim range to account for +/- 20% PVT variation.  The bas frequency of the oscillator is 1.6MHz. 

D17IP11 Current / Voltage Reference
Desert Microtechnology
0.35 μm
XH035
MP
GDSII
Schematic

D17IP11 is both a current and voltage reference with trimming capability.  The current reference uses a negative TC resistor and VBE to reduce the temperature dependence.  The output currents are 2µA and 1µA x2.

D17IP15 Voltage Regulator
Desert Microtechnology
1.00 µm
XC10
MP
GDSII
Schematic

D17IP15 is a voltage regulator with built in reference.  Has 5V low drop out regulator that can operate from 5.5V - 25V supply.  Has 14V regulator when the supply is > 25V.  Can be paired with D17IP16 to generate a voltage oscillator.

D17IP16 Oscillator
Desert Microtechnology
1.00 µm
XC10
MP
GDSII
Schematic

D17IP16 is a voltage oscillator at 500 kHz.  It requires 3 input reference voltages 1.064V, 1.275V and 0.762V.  These voltages can be generated with the D17IP15.  Output is to designed to drive on chip light loads.

aopac01 Operational Amplifier
X-FAB
1.00 µm
XC10
PT
Schematic
Layout
Analog Library

XC10: A_CELLS; A_CELLS_M1. aopac01 is an internally compensated general purpose OpAmp with P-MOS input and common-source output stage.

aopac02 Operational Amplifier
X-FAB
1.00 µm
XC10
PT
Analog Library
Layout
Schematic

XC10: A_CELLS; A_CELLS_M1. aopac02 is an internally compensated rail-to-rail input/output OpAmp.

aopac03 Operational Amplifier
X-FAB
1.00 µm
XC10
PT
Analog Library
Layout
Schematic

XC10: A_CELLS; A_CELLS_M1. aopac03 is an internally compensated general purpose OpAmp with N-MOS input and bipolar pnp output stage.

aopac04 Operational Amplifier
X-FAB
1.00 µm
XC10
PT
Analog Library
Layout
Schematic

XC10: A_CELLS; A_CELLS_M1. aopac04 is a internally compensated general purpose OpAmp with P-MOS input stage.

aopac05 Operational Amplifier
X-FAB
1.00 µm
XC10
PT
Analog Library
Layout
Schematic

XC10: A_CELLS; A_CELLS_M1. aopac05 is a fast internally compensated OpAmp with P-MOS input stage.

 

MP = Mass ProductionPT = Prototyping, Silicon provenID = in DesignVS = Verified by Simulations (Soft-IP)

Displaying results 1 to 30 out of 377

*Disclaimer:
The Intellectual Partner Network is a web database provided by X-FAB in cooperation with selected partners. Both X-FAB and a variety of different IP supplier offer their IP to customers using X-FAB’s foundry process. X-FAB will support customers to get in direct contact with the relevant IP supplier.

X-FAB will take no responsibility nor any liability whatsoever for the information or products offered or provided by the other IP suppliers at the database of the Intellectual Partner Network. X-FAB shall have no liability towards the customers for any use of and/or reliance of the products provided by the other IP suppliers at the database of the Intellectual Partner Network.

X-FAB's own IP is subject to a license agreement. X-FAB IP marked with “*” are part of the Master Kit or Master Kit Plus library. If you can not find the IP you are looking for, please contact the respective sales manager in your region. We continuously extend our libraries and offer a custom cell development service as well.