IP Portal

XB06: A_CELLS. aopac01 is a low power internal frequency-compensated CMOS operational amplifier with pmos input stage

XB06: LNA library: RF_LNA_CELLS. LNA2 is a low noise amplifier. It should be biased by the RF bias cell

CX08A: Analog library. DAC8 is a 8-bit digital-to-analog converter. The architecture is based on two resistor dividers. Because of its high output impedance, which is also code dependent, a low offset buffer operational amplifier is strictly recommen

CX08A: Analog library. DAC10 is a 10-bit digital-to-analog converter. The architecture is based on two resistor dividers. Because of its high output impedance, which is also code dependent, a low offset buffer operational amplifier is strictly recomm

XB06: LNA library: RF_LNA_CELLS. LNA 1 is a low noise amplifier. It shoud be biased by the RF bias cell.

XB06: LNA library: RF_LNA_CELLS. LNA3 is a low noise amplifier with on-chip inductor. It should be biased by the RF bias cell.

XB06: LNA library: RF_LCVCO_CELLS. LCVCO2 is a fully integrated LC-VCO. It should be biased by the RF bias cell. It is based on a cross-coupled bipolar transistor pair. It contains AC-coupled varactors and a special circuit technique for maintaining the D

XB06: LNA library: RF_LCVCO_CELLS. LCVCO3 is a fully integrated LC-VCO. It should be biased by the RF bias cell. It contains a cross-coupled bipolar transistor pair and direct coupled varactors. For this reason, it has a higher tuning range than the other

XB06: LNA library: RF_VCO_CELLS. RINGVCO1 is a fully integrated VCO. It should be biased by the RF bias cell. It consists of a ringoscillator that is tuned by switching the delay chain between 2 and 4 delay stages. The transition between the two borders i

XB06: LNA library: RF_MIXER_CELLS. MIXER is a down conversion mixer based on a Gilbert cell topology. It should be biased by the RF bias cell.

XB06: LNA library: RF_PA_CELLS. PA is a non-linear Power Amplifier that is intended for the transmission of ASK and FSK signals. Its output power level can be digitally controlled in 4 steps. It should be biased by the RF bias cell.

XB06: LNA library: RF_DIVIDER_CELLS. DIV32 is a Prescaler with a fixed divider ratio of 32. It should be biased by the RF bias cell.

XB06: OEIC Building Block Library. OEIC_Fast is a fast DVD receiver channel with two selectable gain settings. Can be integrated with photodiode to form a complete optical receiver channel optimized for 660nm wavelengths.

XB06: OEIC Building Block Library. OEIC_Sensitive is a sensitive DVD receiver channel with two selectable gain settings. Can be integrated with photodiode to form a complete optical receiver channel optimized for 660nm wavelengths.

XC06: A_CELLS_HV. aopac14 is a high-voltage (V_DD up to 10V), low-power, internally-compensated CMOS OpAmp with NMOS input stage.

XC06: A_CELLS_HV. aopac15 is a high-voltage, internally-compensated CMOS OpAmp with NMOS input stage and bipolar emitter-follower output. The incorporated level shifters allow the EN and ENB inputs to be controlled by 5V circuitry.

XC06: A_CELLS_HV. abiac07 is a high-voltage bias cell. The circuit forces a current of 2µA (approx.) to flow through pghv PMOS with W/L ratio of 10µm/10µm and nmv NMOS with W/L ratio of 10µm/12µm.

XC06: A_CELLS_HV. abiac08 is a high-voltage bias cell. THe circuit forces a current of 2µA (approx.) to flow through pgmv PMOS with W/L ratio of 10µm/10µm and nhv NMOS with W/L ratio od 10µm/12µm. The cell features low-cost process option and is a co

XC06: A_CELLS_HV. adrvc01 is a driver circuit for external loads (relays, LEDs, etc). The circuit features NMOS open-drain output (high-side switch). High input voltage makes the output go low (connected to ground). The rising slope of the output signal c

XC06: A_CELLS_HV. adrvc02 is a driver circuit for external loads (relays, LEDs, etc). The circuit features NMOS open-drain output (low-side switch). High input voltage makes the output go low (connected to ground).

XC06: A_CELLS_HV. adrvc03 is a driver circuit for external loads (relays, LEDs, etc). The circuit features NMOS open-drain output (high-side switch). High input voltage makes the output go low (connected to ground). The rising slope of the output signal c

XC06: A_CELLS. aopac01 is a general purpose internally compensated CMOS OpAmp with P-MOS input stage and source follower output stage.

CX08A: Analog library. ADC8 is a 8-bit analog-to-digital converter which utilizes successive-approximation
technique.

XH035: A_CELLS_HV. For MOS module only. aregc02 is a 12V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered via its high-voltage input.

XH035: A_CELLS_HV. For MOS module only. adrvc02 is a driver circuit for external loads (relays, LEDs, etc). The circuit features PNOS open-drain output (high-side switch). The layout of adrvc02 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. adrvc03 is a driver circuit for external loads (realys, LEDs, etc). The circuit features NMOS open-drain output (low-side switch). The layout of adrvc03 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. abiac04 is a high voltage bias cell. The circuit forces a current of 2µA (approx.) to flow through PHV with W/L ratio of 8µm/12µm and NHV with W/L ratio of 8µm/14µm.

XH035: A_CELLS_HV. For MOS module only. arcoc07 is a high-voltage 400kHz current-balancing RC oscillator with internal R and C. The cell features low temperature coefficient of clock frequency, constant duty cycle, and low power consumption.

XH035: LNA Library: RF_LNA_CELLS. LNA1 is a broadband low noise amplifier. It should be bieased by the RF bias cell.

XH035: LNA Library: RF_LNA_CELLS. LNA2 is a narrowband low noise amplifier. It should be biased by the RF bias cell.