IP Portal

Sel. IP Name Category Provider Geometry Process Name Status Deliverable Description
abgpc02 Bandgaps
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. abgpc02 is a general purpose bandgap reference with Poly2 resistors.

abgpc04 Bandgaps
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. abgpc04 is a general purpose bandgap reference with Poly2 resistors.

abgpc07 Bandgaps
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. abgpc07 is a low-supply voltage bandgap reference with N-well resistors. The cell features low supply current and low noise.

abiac01 Bias
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. abiac01 is a general purpose bias cell. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 6µm/6µm and NMOS with W/L ration of 6µm/6µm.

abiac02 Bias
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. abiac02 is a general purpose VTH-based bias cell, a plain substitute for abiac01. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 6µm/6µm and NMOS with W/L ration

abiac03 Bias
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. abiac03 is a general purpose weak inversion bias cell. The circuit forces a current of 200nA (approx.) to flow through PMOS with W/L ratio of 6µm/12µm and NMOS with W?L ration of 6µm/20µm.

acsoc01 Bias
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. acsoc01 is a general purpose current source. The circuit drives a current of 2µA (approx.) at each of its outputs.

acsoc02 Bias
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. acsoc02 is a general purpose current source. The circuit drives a current of 2µA (approx.) at each of its outputs. No reference voltage is necessary.

aadcc02 ADC
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. aadcc02 is a 10-bit successive approximation Analog-to-Digital converter (ADC). The ADC operates with a single 3.3V power supply and external voltage reference.

adacc02 DAC
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. adacc02 is a bit-bit voltage-scaling (potentiometric) Digital-to-Analog converter (DAC). The DAC operates with a single 3.3V power supply and external reference voltage.

arcoc01 Oscillator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. arcoc01 is a 14kHz RC oscillator with internal R and C. The cell features low power consumption and compact size, it is suitable for low-demanding applications.

arcoc02 Oscillator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. arcoc02 is a 200kHz high performance, current-balancing RC oscillator with internal R and C. The cell features very low temperature coefficient of clock frequency and low power consumption.

arcoc03 Oscillator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. arcoc03 is a 1MHz high performance, current-balancing RC oscillator with internal R and C. The cell features very low temperature coefficient of clock frequency and low power consumption.

arcoc04 Oscillator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. arcoc04 is an adjustable 200kHz, current-balancing RC oscillator with internal R and C. The very low temperature and voltage coefficients of clock frequency combined with trimming inputs, very low power consumptio

arcoc05 Oscillator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. arcoc03 is an adjustable 1MHz, current-balancing RC oscillator with internal R and C. The very low temperature and voltage coefficients of clock frequency combined with trimming inputs, very low power consumption

arcoc03 Oscillator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. arcoc06 is a 1 to 10MHz, current-controlled oscillator (CCO) with no external components. Clock frequency is set by means of bias current. The cell features compact size, low temperature and voltage coefficients of clo

axtoc01 Crystal Oscillators
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. axtoc01 is a robust 2 - 8 MHz crystal oscillator for supply voltage range from 2.4 to 3.6V. An external quartz crystal is required.

axtoc02 Crystal Oscillators
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. axtoc02 is a robust 32,768kHz crystal oscillatior for supply voltage range from 2.4 to 2.6V. An external quartz crystal is required.

aporc01 Power on Reset
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. aporc01 is a dynamic Power-on-Reset circuit. During power-on, POR output follows the supply voltage as long as it is below the threshold voltage. When the threshold voltage is reached, the POR signal turns low. A delay

aporc02 Power on Reset
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. aporc02 is a Power-on-Reset circuit with hysteresis. Reset signals are generated on both the rising and falling edge of the supply voltage. During power-on, POR output follows the supply voltage as long as it is b

aporc03 Power on Reset
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS. For MOS module only. aporc03 is a Power-on-Reset circuit. Reset signals are generated on both the rising and falling edge of the supply voltage. During power-on, POR output follows the supply voltage as long as it is below the threshold v

aregc01 Voltage Regulator
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: A_CELLS_HV. For MOS module only. aregc01 is a 5V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered viz its high voltage input.

DIV32 Divider
X-FAB
0.35 μm
XH035
PT
Layout
Schematic
Analog Library

XH035: DIVIDER Library: RF_DIVIDER_CELLS. DIV32 is a Prescaler with a fixed ratio of 32. It should be biased by the RF bias cell.

abiac01_3v3 Bias
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V abiac01_3v3 is a general purpose bias cell. The circuit forces a current of 200nA (approx.) to flow through PMOS with W/L ratio of 8µm/10µm and NMOS with W/L ratio of 4µm/20µm.

abiac02_3v3 Bias
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V abiac02_3v3 is a general purpose bias cell. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 10µm/4µm and NMOS with W/L ratio od 6µm/12µm.

abiac03_3v3 Bias
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V abiac03_3v3 is a general purpose bias cell. The circuit forces a current of 10µA (approx.) to flow through PMOS with W/L ratio of 24µm/2µm and NMOS with W/L ratio od 14µm/6µm.

acsoc01_3v3 Current Source
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V acsoc01_3v3 is a compact general purpose current source. The circuit has four outputs that drive currents of 200nA each. 

acsoc02_3v3 Current Source
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V acsoc02_3v3 is a compact general purpose current source. The circuit has four outputs that drive currents of 1µA; 2µA; 4µA; and 8µA, respectively.

aopac01_3v3 Operational Amplifier
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V aopac01_3v3 is a general purpose internally compensated CMOS OpAmp with N-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of a bias current.

aopac02_3v3 Operational Amplifier
X-FAB
0.18 μm
XC018
PT
Layout
Schematic
Analog Library

XC018 LP 3.3V aopac02_3v3 is a general purpose internally compensated CMOS OpAmp with P-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of bias current.

 

MP = Mass ProductionPT = Prototyping, Silicon provenID = in DesignVS = Verified by Simulations (Soft-IP)

Displaying results 211 to 240 out of 372

*Disclaimer:
The Intellectual Partner Network is a web database provided by X-FAB in cooperation with selected partners. Both X-FAB and a variety of different IP supplier offer their IP to customers using X-FAB’s foundry process. X-FAB will support customers to get in direct contact with the relevant IP supplier.

X-FAB will take no responsibility nor any liability whatsoever for the information or products offered or provided by the other IP suppliers at the database of the Intellectual Partner Network. X-FAB shall have no liability towards the customers for any use of and/or reliance of the products provided by the other IP suppliers at the database of the Intellectual Partner Network.

X-FAB's own IP is subject to a license agreement. X-FAB IP marked with “*” are part of the Master Kit or Master Kit Plus library. If you can not find the IP you are looking for, please contact the respective sales manager in your region. We continuously extend our libraries and offer a custom cell development service as well.