IP Portal

XC06: A_CELLS_HV. aopac14 is a high-voltage (V_DD up to 10V), low-power, internally-compensated CMOS OpAmp with NMOS input stage.

XC06: A_CELLS_HV. aopac15 is a high-voltage, internally-compensated CMOS OpAmp with NMOS input stage and bipolar emitter-follower output. The incorporated level shifters allow the EN and ENB inputs to be controlled by 5V circuitry.

XC06: A_CELLS_HV. abiac07 is a high-voltage bias cell. The circuit forces a current of 2µA (approx.) to flow through pghv PMOS with W/L ratio of 10µm/10µm and nmv NMOS with W/L ratio of 10µm/12µm.

XC06: A_CELLS_HV. abiac08 is a high-voltage bias cell. THe circuit forces a current of 2µA (approx.) to flow through pgmv PMOS with W/L ratio of 10µm/10µm and nhv NMOS with W/L ratio od 10µm/12µm. The cell features low-cost process option and is a co

XC06: A_CELLS_HV. adrvc01 is a driver circuit for external loads (relays, LEDs, etc). The circuit features NMOS open-drain output (high-side switch). High input voltage makes the output go low (connected to ground). The rising slope of the output signal c

XC06: A_CELLS_HV. adrvc02 is a driver circuit for external loads (relays, LEDs, etc). The circuit features NMOS open-drain output (low-side switch). High input voltage makes the output go low (connected to ground).

XC06: A_CELLS_HV. adrvc03 is a driver circuit for external loads (relays, LEDs, etc). The circuit features NMOS open-drain output (high-side switch). High input voltage makes the output go low (connected to ground). The rising slope of the output signal c

XC06: A_CELLS. aopac01 is a general purpose internally compensated CMOS OpAmp with P-MOS input stage and source follower output stage.

CX08A: Analog library. ADC8 is a 8-bit analog-to-digital converter which utilizes successive-approximation
technique.

XH035: A_CELLS_HV. For MOS module only. aregc02 is a 12V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered via its high-voltage input.

XH035: A_CELLS_HV. For MOS module only. adrvc02 is a driver circuit for external loads (relays, LEDs, etc). The circuit features PNOS open-drain output (high-side switch). The layout of adrvc02 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. adrvc03 is a driver circuit for external loads (realys, LEDs, etc). The circuit features NMOS open-drain output (low-side switch). The layout of adrvc03 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. abiac04 is a high voltage bias cell. The circuit forces a current of 2µA (approx.) to flow through PHV with W/L ratio of 8µm/12µm and NHV with W/L ratio of 8µm/14µm.

XH035: A_CELLS_HV. For MOS module only. arcoc07 is a high-voltage 400kHz current-balancing RC oscillator with internal R and C. The cell features low temperature coefficient of clock frequency, constant duty cycle, and low power consumption.

XH035: LNA Library: RF_LNA_CELLS. LNA1 is a broadband low noise amplifier. It should be bieased by the RF bias cell.

XH035: LNA Library: RF_LNA_CELLS. LNA2 is a narrowband low noise amplifier. It should be biased by the RF bias cell.

XH035: BIAS Library: RF_BIAS_CELLS. BIAS is a bias cell intended for use with the various RF building blocks. It is based on a bandgap reference and voltage-to-current converters. Current biasing is preferable because of the higher immunity to interferenc

XC10: A_CELLS; A_CELLS_M1. aopac01 is an internally compensated general purpose OpAmp with P-MOS input and common-source output stage.

XC018 LP 3.3V axtoc02_3v3 is a robust 1-4 MHz crystal oscillator for supply voltage range from 2.4 to 3.6V.

XB06: A_CELLS. aopac02 is an internal frequency-compensated CMOS operational amplifier with p-mos input stage

XC018 LP 3.3V abiac03_3v3 is a general purpose bias cell. The circuit forces a current of 10µA (approx.) to flow through PMOS with W/L ratio of 24µm/2µm and NMOS with W/L ratio od 14µm/6µm.

XC018 LP 3.3V aopac02_3v3 is a general purpose internally compensated CMOS OpAmp with P-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of bias current.

XC018 LP 3.3V aopac01_3v3 is a general purpose internally compensated CMOS OpAmp with N-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of a bias current.

XC018 LP 3.3V acsoc02_3v3 is a compact general purpose current source. The circuit has four outputs that drive currents of 1µA; 2µA; 4µA; and 8µA, respectively.

XC018 LP 3.3V acsoc01_3v3 is a compact general purpose current source. The circuit has four outputs that drive currents of 200nA each. 

XB06: A_CELLS. aopac03 is a fast internal frequency-compensated CMOS operational amplifier with p-mos input stage

XB06: A_CELLS. aopac05 is a low power internal frequency-compensated CMOS operational amplifier with nmos input stage

XB06: A_CELLS. aopac06 is an internal frequency-compensated CMOS operational amplifier with n-mos input stage

XB06: A_CELLS. aopac07 is a fast internal frequency-compensated CMOS operational amplifier with n-mos input stage.

XB06: A_CELLS. aopac09 is an internal frequency-compensated CMOS operational amplifier with p-mos input stage and rail-to-rail output stage.