IP Portal

XH035: A_CELLS. For MOS module only. aadcc02 is a 10-bit successive approximation Analog-to-Digital converter (ADC). The ADC operates with a single 3.3V power supply and external voltage reference.

XH035: A_CELLS. For MOS module only. adacc02 is a bit-bit voltage-scaling (potentiometric) Digital-to-Analog converter (DAC). The DAC operates with a single 3.3V power supply and external reference voltage.

XH035: A_CELLS. For MOS module only. arcoc01 is a 14kHz RC oscillator with internal R and C. The cell features low power consumption and compact size, it is suitable for low-demanding applications.

XH035: A_CELLS. For MOS module only. arcoc02 is a 200kHz high performance, current-balancing RC oscillator with internal R and C. The cell features very low temperature coefficient of clock frequency and low power consumption.

XH035: A_CELLS. For MOS module only. arcoc03 is a 1MHz high performance, current-balancing RC oscillator with internal R and C. The cell features very low temperature coefficient of clock frequency and low power consumption.

XH035: A_CELLS. For MOS module only. arcoc04 is an adjustable 200kHz, current-balancing RC oscillator with internal R and C. The very low temperature and voltage coefficients of clock frequency combined with trimming inputs, very low power consumptio

XH035: A_CELLS. For MOS module only. arcoc03 is an adjustable 1MHz, current-balancing RC oscillator with internal R and C. The very low temperature and voltage coefficients of clock frequency combined with trimming inputs, very low power consumption

XH035: A_CELLS. For MOS module only. arcoc06 is a 1 to 10MHz, current-controlled oscillator (CCO) with no external components. Clock frequency is set by means of bias current. The cell features compact size, low temperature and voltage coefficients of clo

XH035: A_CELLS. For MOS module only. axtoc01 is a robust 2 - 8 MHz crystal oscillator for supply voltage range from 2.4 to 3.6V. An external quartz crystal is required.

XH035: A_CELLS. For MOS module only. axtoc02 is a robust 32,768kHz crystal oscillatior for supply voltage range from 2.4 to 2.6V. An external quartz crystal is required.

XH035: A_CELLS. For MOS module only. aporc01 is a dynamic Power-on-Reset circuit. During power-on, POR output follows the supply voltage as long as it is below the threshold voltage. When the threshold voltage is reached, the POR signal turns low. A delay

XH035: A_CELLS. For MOS module only. aporc02 is a Power-on-Reset circuit with hysteresis. Reset signals are generated on both the rising and falling edge of the supply voltage. During power-on, POR output follows the supply voltage as long as it is b

XH035: A_CELLS. For MOS module only. aporc03 is a Power-on-Reset circuit. Reset signals are generated on both the rising and falling edge of the supply voltage. During power-on, POR output follows the supply voltage as long as it is below the threshold v

XH035: A_CELLS_HV. For MOS module only. aregc01 is a 5V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered viz its high voltage input.

XH035: A_CELLS_HV. For MOS module only. aregc02 is a 12V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered via its high-voltage input.

XH035: A_CELLS_HV. For MOS module only. adrvc02 is a driver circuit for external loads (relays, LEDs, etc). The circuit features PNOS open-drain output (high-side switch). The layout of adrvc02 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. adrvc03 is a driver circuit for external loads (realys, LEDs, etc). The circuit features NMOS open-drain output (low-side switch). The layout of adrvc03 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. abiac04 is a high voltage bias cell. The circuit forces a current of 2µA (approx.) to flow through PHV with W/L ratio of 8µm/12µm and NHV with W/L ratio of 8µm/14µm.

XH035: A_CELLS_HV. For MOS module only. arcoc07 is a high-voltage 400kHz current-balancing RC oscillator with internal R and C. The cell features low temperature coefficient of clock frequency, constant duty cycle, and low power consumption.

XH035: LNA Library: RF_LNA_CELLS. LNA1 is a broadband low noise amplifier. It should be bieased by the RF bias cell.

XH035: LNA Library: RF_LNA_CELLS. LNA2 is a narrowband low noise amplifier. It should be biased by the RF bias cell.

XH035: DIVIDER Library: RF_DIVIDER_CELLS. DIV32 is a Prescaler with a fixed ratio of 32. It should be biased by the RF bias cell.

XH035: BIAS Library: RF_BIAS_CELLS. BIAS is a bias cell intended for use with the various RF building blocks. It is based on a bandgap reference and voltage-to-current converters. Current biasing is preferable because of the higher immunity to interferenc

Connectivity IP. This is a product chip.

Power On Reset cell

Reference Amplifier

Operational Amplifier Cell with P-Channel Inputs

Resistive String architecture.

Comparator Cell with N-Channel Inputs

Current Reference and Current Biasing Cell.