IP Portal

XT06 axtoc02 is a 1...4MHz crystal oscillator for supply voltage range from 3.5 to 5.5V. An external quartz crystal as to be connected to XTALIN and XTALOUT pins.

XT06 axtoc03 is a 1...6MHz crystal oscillator for supply voltage range from 3.3 to 5.5V. An external quartz crstal has to be connected to XTALIN and XTALOUT pins.

XT06 aporc01 is a dynamic Power-on-Reset circuit. During power-on, POR output is kept high as long as the supply voltage is below the POR threshold voltage. When the threshold voltage is reached, the POR signal turns low.

XT06 aporc02 is a Power-on-Reset circuit with hysteresis. Reset signal are generated on both the rising and failing edge of the supply voltage. During power-on, POR outputs is kept high as long as the supply voltage is below the threshold voltage.

XT06 aporc03 is a Power-on-Rest circuit. Reset signals are generated on both the rising and falling edge of the supply voltage. During power-on, POR output is kept high as long as the supply voltage is below the high threshold.

XT06 achpc01 is a doubling charge pump 3.3V => 5.6V.

DC/DC regulator.

DC/DC Buck Regulator with 0% to 100% duty cycle.

The ADC12DR is a SAR-based low-power ADC with a 12bit resolution. Its fully differential input stage features a rail-to-rail input range. At a sampling rate of 2MS/s a power consumption of only 10mW is attained applying a 5V power suppl

XH035: A_CELLS. For MOS module only. aopac01 is a general purpose internally compensated CMOS OpAmp with N-MOS input stage and rail-to-tail output stage.

XH035: A_CELLS. For MOS module only. aopac02 is a general purpose internally compensated CMOS OpAmp with P-MOS input stage and rail-to-rail output stage.

XH035: A_CELLS. For MOS module only. aopac03 is a general purpose internally compensated rai-to-rail input, rail-to-rail output CMOS OpAmp. It features low input offset voltage and high output driving capabilities.

XH035: A_CELLS. For MOS module only. aopac04 is a general purpose internally compensated rail-to-rail input, rail-to-rail output CMOS OpAmp. Features precision quiescent current control & high output driving capabilities.

XH035: A_CELLS. For MOS module only. aopac05 is a low-power internally compensated with P-MOS input and rail-to-rail output.

XH035: A_CELLS. For MOS module only. aopac06 is a fast internally compensated with N-MOS input and rail-to-rail output.

XH035: A_CELLS. For MOS module only. aopac08 is a general purpose internally compensated operational amplifier with N-MOS input and emitter-follower output.

XH035: A_CELLS. For MOS module only. aopac12 is an internally compensated CMOS differential input - differential output (DIDO) operational amplifier with P-MOS input stage and rail-to-rail output stages.

XH035: A_CELLS. For MOS module only. acmpc01 is a low-power CMOS comparator with hysteresis. The input stage is P-MOS differential pair.

XH035: A_CELLS. For MOS module only. acmpc02 is a low-power CMOS comparator with hysteresis. The input stage is N-MOS differential pair.

XH035: A_CELLS. For MOS module only. acmpc03 is a rail-to-rail CMOS comparator.

XH035: A_CELLS. For MOS module only. acmpc04 is a current-programmable rail-to-rail CMOS voltage comparator. The speed and the power consumption of the cell are programmed by means of bias current.

XH035: A_CELLS. For MOS module only. abgpc01 is a general purpose bandgap reference with N-well resistors.

XH035: A_CELLS. For MOS module only. abgpc02 is a general purpose bandgap reference with Poly2 resistors.

XH035: A_CELLS. For MOS module only. abgpc04 is a general purpose bandgap reference with Poly2 resistors.

XH035: A_CELLS. For MOS module only. abgpc07 is a low-supply voltage bandgap reference with N-well resistors. The cell features low supply current and low noise.

XH035: A_CELLS. For MOS module only. abiac01 is a general purpose bias cell. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 6µm/6µm and NMOS with W/L ration of 6µm/6µm.

XH035: A_CELLS. For MOS module only. abiac02 is a general purpose V_TH-based bias cell, a plain substitute for abiac01. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 6µm/6µm and NMOS with W/L ration

XH035: A_CELLS. For MOS module only. abiac03 is a general purpose weak inversion bias cell. The circuit forces a current of 200nA (approx.) to flow through PMOS with W/L ratio of 6µm/12µm and NMOS with W?L ration of 6µm/20µm.

XH035: A_CELLS. For MOS module only. acsoc01 is a general purpose current source. The circuit drives a current of 2µA (approx.) at each of its outputs.

XH035: A_CELLS. For MOS module only. acsoc02 is a general purpose current source. The circuit drives a current of 2µA (approx.) at each of its outputs. No reference voltage is necessary.