IP Portal

XH035: A_CELLS_HV. For MOS module only. aregc01 is a 5V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered viz its high voltage input.

XH035: A_CELLS_HV. For MOS module only. aregc02 is a 12V/3.3V linear voltage regulator for up to 20mA load current. The regulator is powered via its high-voltage input.

XH035: A_CELLS_HV. For MOS module only. adrvc02 is a driver circuit for external loads (relays, LEDs, etc). The circuit features PNOS open-drain output (high-side switch). The layout of adrvc02 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. adrvc03 is a driver circuit for external loads (realys, LEDs, etc). The circuit features NMOS open-drain output (low-side switch). The layout of adrvc03 makes it easy to incorporate in the flat IO ring.

XH035: A_CELLS_HV. For MOS module only. abiac04 is a high voltage bias cell. The circuit forces a current of 2µA (approx.) to flow through PHV with W/L ratio of 8µm/12µm and NHV with W/L ratio of 8µm/14µm.

XH035: A_CELLS_HV. For MOS module only. arcoc07 is a high-voltage 400kHz current-balancing RC oscillator with internal R and C. The cell features low temperature coefficient of clock frequency, constant duty cycle, and low power consumption.

XH035: LNA Library: RF_LNA_CELLS. LNA1 is a broadband low noise amplifier. It should be bieased by the RF bias cell.

XH035: LNA Library: RF_LNA_CELLS. LNA2 is a narrowband low noise amplifier. It should be biased by the RF bias cell.

XH035: DIVIDER Library: RF_DIVIDER_CELLS. DIV32 is a Prescaler with a fixed ratio of 32. It should be biased by the RF bias cell.

XH035: BIAS Library: RF_BIAS_CELLS. BIAS is a bias cell intended for use with the various RF building blocks. It is based on a bandgap reference and voltage-to-current converters. Current biasing is preferable because of the higher immunity to interferenc

XC018 LP 3.3V abiac01_3v3 is a general purpose bias cell. The circuit forces a current of 200nA (approx.) to flow through PMOS with W/L ratio of 8µm/10µm and NMOS with W/L ratio of 4µm/20µm.

XC018 LP 3.3V abiac02_3v3 is a general purpose bias cell. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 10µm/4µm and NMOS with W/L ratio od 6µm/12µm.

XC018 LP 3.3V abiac03_3v3 is a general purpose bias cell. The circuit forces a current of 10µA (approx.) to flow through PMOS with W/L ratio of 24µm/2µm and NMOS with W/L ratio od 14µm/6µm.

XC018 LP 3.3V acsoc01_3v3 is a compact general purpose current source. The circuit has four outputs that drive currents of 200nA each. 

XC018 LP 3.3V acsoc02_3v3 is a compact general purpose current source. The circuit has four outputs that drive currents of 1µA; 2µA; 4µA; and 8µA, respectively.

XC018 LP 3.3V aopac01_3v3 is a general purpose internally compensated CMOS OpAmp with N-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of a bias current.

XC018 LP 3.3V aopac02_3v3 is a general purpose internally compensated CMOS OpAmp with P-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of bias current.

XC018 LP 3.3V acmpc01_3v3 is a low-power current-programmable CMOS comparator with hysteresis. The input stage is P-MOS differential pair. The speed and power consumption of the comparator can be controlled by means of the bias current through the IBN inp

XC018 LP 3.3V acmpc02_3v3 is a low-power current-programmable CMOS comparator with hysteresis. The input stage is N-MOS differential pair.

XC018 LP 3.3V acmpc03_3v3 is a rail-to-rail input, current-programmable CMOS comparator. The speed and power consumption of the comparator can be controlled by means of the bias current through the IBN input.

XC018 LP 3.3V aadcc01_3v3 is a 10-bit successive approximation Analog-to-Digital converter (ADC). The ADC operates with a single 3.3V power supply and an external voltage reference.

XC018 LP 3.3V adacc01_3v3 is a 10-bit voltage-scaling (potentionetric) Digital-to-Analog converter (DAC). The adacc01 DAC operates with a single 3.3V power supply and external reference voltage.

XC018 LP 5V abiac06_5v is a general purpose bias cell. The circuit forces a current of 10µA (approx.) to flow through PMOS with W/L ratio of 24µm/3µm and NMOS with W/L ratio of 10µm/4µm.

XC018 LP 5V abiac07_5v is a general purpose bias cell. The circuit forces a current of 2µA (approx.) to flow through PMOS with W/L ratio of 10µm/6µm and NMOS with W/L ratio of 10µm/12µm.

XC018 LP 5v acsoc01_5v is a compact general purpose current source. The circuit has four outputs that drive currents of 1µA, 2µA, 4µA, and 8µA, respectively.

XC018 LP 5v acsoc02_5v is a compact general purpose current source. The circuit has four outputs that drive currents of 200nA each.

XC018 LP 5V aopac01_5v is a general purpose internally compensated CMOS OpAmp with N-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of bias current.

XC018 LP 5V aopac02_5v is a general purpose internally compensated CMOS OpAmp withP-MOS input stage and rail-to-rail output stage. The speed, gain bandwidth, and the power consumption of the amplifier are set by means of bias current.

XC018 LP 5V acmpc01_5v is a low-power current-programmable CMOS comparator with hysteresis. The input stage is P-MOS differential pair. The speed and power consumption of the comparator can be controlled by means of the bias current through the IBN input.

XC018 LP 5V acmpc02_5v is a low-power current-programmable CMOS comparator with hysteresis. The input stage is N-MOS differential pair. The speed and power consumption of the comparator can be controlled by means of the bias current through the IBN input.