dac10 * DAC X-FAB 0.80 µm CX08 PT Schematic CX08A: Analog library. DAC10 is a 10-bit digital-to-analog converter. The architecture is based on two resistor dividers. Because of its high output impedance, which is also code dependent, a low offset buffer operational amplifier is strictly recomm
LNA1 * LNA X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_LNA_CELLS. LNA 1 is a low noise amplifier. It shoud be biased by the RF bias cell.
LNA2 * LNA X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_LNA_CELLS. LNA2 is a low noise amplifier. It should be biased by the RF bias cell
LNA3 * LNA X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_LNA_CELLS. LNA3 is a low noise amplifier with on-chip inductor. It should be biased by the RF bias cell.
LCVCO2 * VCO X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_LCVCO_CELLS. LCVCO2 is a fully integrated LC-VCO. It should be biased by the RF bias cell. It is based on a cross-coupled bipolar transistor pair. It contains AC-coupled varactors and a special circuit technique for maintaining the D
LCVCO3 * VCO X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_LCVCO_CELLS. LCVCO3 is a fully integrated LC-VCO. It should be biased by the RF bias cell. It contains a cross-coupled bipolar transistor pair and direct coupled varactors. For this reason, it has a higher tuning range than the other
RINGVCO1 * VCO X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_VCO_CELLS. RINGVCO1 is a fully integrated VCO. It should be biased by the RF bias cell. It consists of a ringoscillator that is tuned by switching the delay chain between 2 and 4 delay stages. The transition between the two borders i
MIXER * Mixer X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_MIXER_CELLS. MIXER is a down conversion mixer based on a Gilbert cell topology. It should be biased by the RF bias cell.
PA * Power Amplifiers X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_PA_CELLS. PA is a non-linear Power Amplifier that is intended for the transmission of ASK and FSK signals. Its output power level can be digitally controlled in 4 steps. It should be biased by the RF bias cell.
DIV32 * Divider X-FAB 0.60 µm XB06 PT Schematic XB06: LNA library: RF_DIVIDER_CELLS. DIV32 is a Prescaler with a fixed divider ratio of 32. It should be biased by the RF bias cell.
BIAS * Bias X-FAB 0.60 µm XB06 PT Verilog XB06: LNA library: RF_BIAS_CELLS. BIAS is a bias cell intended for use with various RF building blocks. It is designed as a bandgap reference as well as voltage-to-current converter. Current biasing is preferable because of the higher immunity to interfer
HT_ADC1 ADC IMMS GmbH 1.00 µm XI10 PT GDSII This IP is a cyclic ADC based on RSD algorithm usable as core for embedded applications. The special advantage of this type of ADC is the reduced complexity of hardware resp. layout area because of the reuse of the main stages for each bit. Up to 13 bit o
OEIC_Fast * Optical Receiver Channel X-FAB 0.60 µm XB06 PT Schematic XB06: OEIC Building Block Library. OEIC_Fast is a fast DVD receiver channel with two selectable gain settings. Can be integrated with photodiode to form a complete optical receiver channel optimized for 660nm wavelengths.
OEIC_Sensitive * Optical Receiver Channel X-FAB 0.60 µm XB06 PT Schematic XB06: OEIC Building Block Library. OEIC_Sensitive is a sensitive DVD receiver channel with two selectable gain settings. Can be integrated with photodiode to form a complete optical receiver channel optimized for 660nm wavelengths.
DPIN * Integrated Photodiode X-FAB 0.60 µm XB06 PT Schematic XB06: OEIC Building Block Library. DPIN_5050 and DPIN_50100 are fast photodiodes with a vertical PIN structure optimized forred light (660nm).
aopac01 * Operational Amplifier X-FAB 0.60 µm XB06 PT Schematic XB06: A_CELLS. aopac01 is a low power internal frequency-compensated CMOS operational amplifier with pmos input stage
aopac02 * Operational Amplifier X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. aopac02 is an internal frequency-compensated CMOS operational amplifier with p-mos input stage
aopac03 * Operational Amplifier X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. aopac03 is a fast internal frequency-compensated CMOS operational amplifier with p-mos input stage
aopac05 * Operational Amplifier X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. aopac05 is a low power internal frequency-compensated CMOS operational amplifier with nmos input stage
aopac06 * Operational Amplifier X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. aopac06 is an internal frequency-compensated CMOS operational amplifier with n-mos input stage
aopac07 * Operational Amplifier X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. aopac07 is a fast internal frequency-compensated CMOS operational amplifier with n-mos input stage.
aopac09 * Operational Amplifier X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. aopac09 is an internal frequency-compensated CMOS operational amplifier with p-mos input stage and rail-to-rail output stage.
aopac10 * Operational Amplifier X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. aopac10 is an internal frequency-compensated CMOS operational amplifier with rail-to-rail input stage and rail-to-rail output stage.
acmpc01 * Comparators X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. acmpc01 is a low-power two-stage CMOS comparator with n-mos input stage and a CMOS-output stage.
acmpc03 * Comparators X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. acmpc03 is a low-power two-stage CMOS comparator with n-mos input stage and a CMOS-output stage.
acmpc04 * Comparators X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. acmpc04 is a two-stage CMOS comparator with p-mos input stage and a CMOS-output stage.
acmpc06 * Comparators X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. acmpc06 is a two-stage CMOS comparator with p-mos input stage and a CMOS-output stage.
acmpc10 * Comparators X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. acmpc10 is a CMOS comparator with rail-to-rail input stage and rail-to-rail output stage.
acmpc11 * Comparators X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. acmpc11 is low offset CMOS comparator with rail-to-rail input stage and rail-to-rail output stage.
abgpc01 * Bandgaps X-FAB 0.60 µm XB06 PT Layout XB06: A_CELLS. abgpc01 is a Brokaw, general-purpose bandgap reference source with high resistive poly resistor.
